Preparation for increasing pH CRANIT pH plus 0.9kg
TI6438467
Designed to increase the pH value of pool water. The ideal pH value of bathing water should be in the range of 6.8 – 7.6. In this range, disinfectants work with maximum efficiency and without negative side effects.
Instructions
Slowly add the necessary amount of product (dissolved in water in a plastic container) at the water inlet to the pool with the filter device switched on. Check the pH value (testers) only after complete mixing. Repeat this process until the pH is in the desired range. The presence of people in the pool must be excluded until the preparation has been perfectly mixed by the filter device! Then check the pH value once a week and regulate any detected deviations from the ideal value by adding Cranit pH plus or Cranit pH minus. Inspection is necessary especially before adding disinfectants.
Dosage
10 g of product (1 level tablespoon) per 1 m3 (1,000 liters) of water will increase the pH value by approximately 0.2 (a higher dose is usually needed for soft water).
Hazard identification
Signal word: WARNING
H319 Causes serious eye irritation.
P101 If medical attention is needed, have product container or label at hand.
P102 Keep out of reach of children.
P501 Dispose of contents/container to hazardous waste!
P280 Wear protective gloves/protective clothing/safety glasses/face shield.
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if worn and if they can be removed easily. Continue rinsing.
P337+P313 If eye irritation persists: Get medical advice/treatment.
Brand
DEN BRAVEN
E.A.N
8595100128201
Effettua l'accesso così da poter essere ricontattato
