Silicone for sealing the engine part K2 black 85g
TI6560807
K2 SILICON BLACK 85g - is a high-quality silicone, safe for lambda probes, on-board computers, meets the requirements of car manufacturers (O.E.M. – Original Equipment Manufacturer). It replaces traditional cork, paper, felt, asbestos and rubber seals. Thanks to the SENSOR SAFE formula, it does not damage lambda sensors in modern cars with electronic fuel injection. Resistant to: oils, lubricants, coolants, etc. Can be used in all types and brands of cars for sealing: thermostat compartment cover, oil pans, water pump cover, cooling connection ends, and others. Resistant to temperatures up to +350°C.
Instructions for use: The surface must be dry, cleaned of dust, dirt and grease. Remove the old, loose gasket. Apply a small amount of silicone. Any excess can be removed using a knife dipped in soapy water. The silicone starts to dry after 5 minutes and is touch resistant after 1 hour. Complete drying occurs after 24 hours. Excess dried silicone can be removed with a razor blade. The tube must be closed properly after each use.
Brand
K2
E.A.N
5906534000798
Effettua l'accesso così da poter essere ricontattato
