Sink faucet with electric water heating HAKL OB 500
TI6443215
Direct heating battery
flexible, shape-adaptable spout arm
battery body made of stainless steel
connection to an electrical socket above the sink or under the sink
display with the exact temperature of the heated water
thermal protection against overheating of the heating spiral, in case of an emergency without the need to disassemble the battery
active aerator that works reliably both at low and full water flow
compact design, heater and battery in one
trouble-free installation on the cold water supply
The power of the heating spiral (3.3 kW) is sufficient for ordinary washing of hands, dishes and small household items. The HAKL OB 500 direct heating battery just needs to be connected to the cold water supply and to the electrical network using a plug.
The surface of the hanger is made of high-quality durable neoprene foam, in addition to the aesthetic appearance, it also has good insulating properties, you will not burn yourself when handling the hanger.
In the event of an emergency (e.g. air in the water pipe), the thermal fuse cuts off the electrical supply and thus protects the heating coil from overheating.
The thermal fuse does not need to be replaced in the service department, it is enough to manually return it to operating condition.
The direct heating battery HAKL OB 500 can be connected to the electrical network above or below the sink without the need to dismantle the supply cable.
You only need to change the mounting reduction that is included in the package.
The function of the aerator - water straightener is very important. It can create a sufficient volume of water even at a very low flow rate, it "peels" the water and optically increases its flow rate.
With the aerator supplied as standard, the water saving is up to approx. 70%. In the offer, the manufacturer also has an aerator with a larger flow, where savings of about 50% are achieved. This aerator is recommended to be purchased if the direct heating battery is installed in a water system with higher water pressure.
Technical parameters:
Power consumption: 3.3 kW
Voltage: 230V
Fuse: 16A
Degree of protection: IP 24
Pressure operation: yes
Max. permanent water pressure: 6 bar
Min. switching pressure: 1.0 bar
Switching type: hydraulic
Heating signal: yes
Water temperature display: yes
Spacing of connection outlets: 1 inlet
Connection threads: 1/2" external
Water flow at 40 °C: 1.79 l/min
Water flow at 60 °C: 1.09 l/min
Antifreeze fuse: no
The product may contain cable: yes
Cable termination with a fork: yes
Connection cable type: 3C 1.5mm Flexo
Length of connection cable: 100 cm
Net weight: 1.28 kg
Product dimensions (h x w x d): 36.5 x 10 x 6.7 cm
Brand
HAKL
E.A.N
8586018642262
Effettua l'accesso così da poter essere ricontattato
